Block/assembler

Assembler

This machine is used to assemble a robot from its individual parts. You can configure your robot in a lot of detail here, but keep in mind that most parts will be fixed once the robot is assembled, so choose wisely. Assembly takes a short amount of time, but consumes a good bit of energy.

For a basic robot you will generally want to add the parts you also use to build a computer, i.e. a CPU, RAM, a medium with an operating system on it, and unless you want a "headless" robot, a screen, a keyboard and a GPU.

Since version 1.3.

The Assembler is crafted using the following recipe:

• 4 x Iron Ingot
• 1 x Crafting Table
• 2 x Piston (or Sticky Piston)
• 1 x Microchip (Tier 2)
• 1 x Printed Circuit Board

Here's a map to the component slots for assembly automation:

The red numbers on the image seen above are the same for all of the assembly cases.

Contents

Blocks	Category	Documentation
Blocks	Computers	Computer Case - Server Rack - Microcontrollers
	Display	Hologram Projector - Keyboard - Screen
	Power and Networking	Access Point - Capacitor - Net Splitter - Power Converter - Power Distributor - Relay
	Extensions	Adapter - Cable - Disassembler - Disk Drive - Geolyzer - Motion Sensor - Redstone I/O - Transposer - 3D Printer
	Robotics	Assembler - Charger - Drone - Robot - Waypoint